Bitkit 2 USB Programming Cable
Item #: BITKITUSBPC
$19.95
Out of stock - not available to order
Bitkit2 USB programming cable. This is an optional way of programming and loading games to your Bitkit 2 board in place of Wifi or Bluetooth. You must follow the instructions in the Bitkit2 Setup Guide.
Features:
- 6 ft USB to TTL serial adapter (with 3 pin 0.1” pitch female header socket) connects devices with 3.3 V logic level UART signals interface to a laptop via USB port
- A genuine FT232RL chip module is housed in a USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates
- 6 feet FTDI USB to TTL serial cable (3-way output flying leads ) provides access to UART (transmit) Tx, (receive) Rx, and GND
- FTDI chipset on the PCB board has configurable internal EEPROM and 3.3V UART signals can be individually inverted by configuring the EEPROM
- 3V3 TTL to USB converter cord is compatible with Windows 11, 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater; ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set-top box, transmitter, flash firmware on hard drive, etc.
Note: This is not a power/charging cable, you must power the Bitkit via a JAMMA harness.